Phone Number:
1-204-727-8111

Long Burning Fire Log

The PowerLogs offer complete combustion leaving behind a small amount of fine ash with no clinkers. Many of our customers applaud the fact that the PowerLogs continue to radiate heat through the night & in most cases offer glowing red coals in the morning to start another fire. During the manufacturing process the PowerLogs are heated in excess of 150 degrees Celsius which most certainly eliminates any possibility of bugs or funguses commonly found in cord wood.

The PowerLogs can be safely stored inside your home. The PowerLogs take up far less space than the equivalent amount of cord wood to produce the same heat output

Humidity is not absorbed by the PowerLogs but they must be protected from direct contact with moisture.

The PowerLogs are 4 inches in diameter, 10 inches log and weigh about 4 ½ pounds. When the PowerLogs are burned they do not expand like some densified sawdust logs which are not near as tightly compressed.

When tested by Omni Laboratories the PowerLog was noted to contain 8,644 BTU’s of heat per pound! A single 4 ½ pound PowerLog contains almost 39,000 BTU’s of heat. This is more heat per pound than any cord wood and even lignite coal.


Break off a few pieces of a log and place over the fire starter or kindlilng.	Once the fire is established, place full PowerLogs beside and on top.	PowerLogs after 3 hours of burning	After burning for 10 hours there are still red hot glowing coals